IBM 10/100 EtherJet User Manual page 13

For Windows 95 OSR2.1 or OSR2.5
Have your Windows 95 CD or diskettes available; you will need them during the
installation. To install the driver, do as follows:
3
Click OK.
4
Insert the drivers CD-ROM.
5
When you are prompted to specify the path that the device driver is in, type
x:\ETHERNET, where x is the drive letter of the CD-ROM drive.
6
Click OK.
7
Follow the instructions on the screen.
8
When you are prompted to specify the path that the device driver is in, type
x:\ETHERNET, where x is the drive letter of the CD-ROM drive.
9
Follow the instructions on the screen.
10
When you are prompted, restart your system.
Hints
If you can't connect to a server, or if Windows 95 reports an error after you
double-click Network Neighborhood, do as follows:
Make sure that you're using the drivers from the driver CD shipped with the
Combo card.
Make sure that the driver is loaded and the protocols are bound. Check the
Device Properties list for trouble indicators (if there is trouble, an X or ! symbol
appears beside the icon).
Ask your LAN administrator whether you need to install additional networking
software.
If the problem persists, go to "Troubleshooting" on page 7.
1
Start Windows 95.
The "Update Device Driver Wizard" dialog box appears.
2
Insert the drivers CD-ROM.
3
Click Next.
4
Click Other Location...
5
Specify x:\ETHERNET, where x is the drive letter of the CD-ROM drive.
6
When the "Windows found the following update driver for this device: Intel(R)
PRO/100+ MiniPCI" message appears, click Finish.
7
When you are prompted to specify the path that the device driver is in, type
x:\ETHERNET, where x is the drive letter of the CD-ROM drive.
8
Click OK.
For Windows 95 OSR2.1 or OSR2.0
Using the LAN
3