Using The Modem; Installing The Modem Driver; Using The Modem Abroad - IBM 10/100 EtherJet User Manual

Using the modem

After you install the Combo card in your computer, connect a modem cable to the
modem connector at the rear of the computer.

Installing the modem driver

To install the modem driver, do as follows:
As you configure your communication software, you will be prompted to select a modem.
Select Xircom MPCI Modem 56 WinGlobal.
Note: When you reinstall the Mini PCI, reinstall the drivers, too.

Using the modem abroad

This section provides the information for using the modem outside of your country. For
the list of the regions of support the use of the Combo card, see the online information on
your computer.
Setting up the dialing properties
When you use the Combo card outside of the country where it was set up, reset the
dialing properties, as follows:
The regions where IBM supports the use of your modem are listed in the on-line manual.
If you select a region not on that list, your modem might not work correctly.
 Copyright IBM Corp. 2000
1
Start Windows.
The "New Hardware Found" dialog or the "Update Device Driver Wizard" dialog
appears.
2
Click Cancel.
3
Insert the IBM 10/100 EtherJet Mini-PCI Adapter with 56K Modem drivers
CD-ROM.
4
Click Start and Run.
5
Type x:\MODEM\setup.exe
where x is the drive letter of the CD-ROM drive.
6
Follow the instructions on the screen.
7
Restart the system.
1
Click Start and move the cursor to Settings; then click Control Panel.
2
Double-click Modem.
3
Double-click Dialing Properties.
4
In the Country/Region section, select the region where you are going to use the
modem.
Using the modem abroad
15