Maintenance; Using Tftp Server; Download Configuration File - IBM BladeCenter Installation And User Manual

The switch can record event information in its own logs, to designated SNMP trap
receiving stations, and to the PC connected through a Telnet interface. Clicking
Next at the bottom of the window will enable you to display all the switch trap logs.
The information on this window is described as follows:
Sequence
Time
Log Text

Maintenance

This section includes Using TFTP Server (Download Configuration File,
Upgrade Firmware, Upload Configuration File, and Save Log), Using Browser
(Upgrade Firmware/Configuration File and Download Configuration/Log Files),
Save Changes, Factory Reset, and Restart System.

Using TFTP Server

Trivial File Transfer Protocol (TFTP) services enable the switch firmware code to be
upgraded by downloading a new firmware code file from a TFTP server to the
switch. A configuration file can also be loaded into the switch, and switch settings
can be saved to a TFTP server. In addition, the switch history log can be uploaded
from the switch to a TFTP server.
Note: TFTP server software must be running on the management station for the

Download Configuration File

The Download Configuration File from TFTP Server window contains the following
information:
68
IBM BladeCenter 4-Port Gb Ethernet Switch Module: Installation and User's Guide
A counter incremented whenever an entry to the switch history log is made.
The table displays the last entry (highest sequence number) first.
Displays the time in days, hours, and minutes since the switch was last
restarted.
Displays text describing the event that triggered the history log entry.
TFTP services listed here to work.