Restarting The Switch Module - IBM BladeCenter Installation And User Manual

Restarting the switch module

The switch module has several reboot (restart) options.
To restart the switch, highlight Reboot in the main menu and press Enter.
The reboot options are as follows:
Reboot
Save Configuration & Reboot
Reboot & Load Factory Default Configuration
Reboot & Load Factory Default Configuration Except IP Address
A confirmation window will open.
Restarts the switch. Any configuration settings that are not saved through
Save Changes in the main menu will be lost. The switch configuration will
be restored to the last configuration that was saved in NVRAM.
Saves the configuration to NVRAM (identical to using Save Changes) and
then restarts the switch.
Restarts the switch using the default factory configuration. All configuration
data will be lost. This is identical to using Factory Reset and then Reboot.
Restarts the switch using the default factory configuration, except the user
configured IP address will be retained. All other configuration data will be
lost.
Chapter 6. Configuring the switch module through the Telnet interface
97