Chapter 7. Maintaining the hardware
This chapter provides instructions for maintaining the hardware. See the "Safety
notices" on page xiii before starting any of these procedures.
CAUTION:
Servicing of this product or unit is to be performed by trained service
personnel only. (C032)
Hardware maintenance schedule
The chassis requires minimal maintenance for its hardware components. IBM
recommends cleaning the fiber-optic connectors on a fiber-optic port and the
connected fiber cable each time you disconnect the cable.
Otherwise, you can replace the following hardware components as needed:
v Management and interface modules
v Switch fabric modules
v POE daughter card
v Copper and fiber optic modules (SFPs and XFP transceivers)
v Power supplies
v Fan tray
v Blowers
Cleaning the fiber optic connectors
To avoid problems with the connection between the fiber optic module (SFP or
XFP) and the fiber cable connectors, IBM strongly recommends cleaning both
connectors each time you disconnect and reconnect them. In particular, dust can
accumulate in the connectors and cause problems such as reducing the optic
launch power.
To clean the fiber cable connectors, IBM recommends using the fiber-optic reel-type
cleaner that shipped with your chassis.
When not using an SFP or XFP connector, make sure to keep the protective
covering on it.
Replacing a management module
This section provides information about the following tasks:
v Removing a management module
v Installing a new management module
This section provides instructions for removing and installing the management
modules in the B08S, and B16S.
Installation precautions
Note the following when removing and installing a management module:
© Copyright IBM Corp. 2009
91