Igmp Snooping - IBM BladeCenter Installation And User Manual

IGMP Snooping

IGMP Snooping can be globally enabled or disabled from the IGMP Snooping
window.
To configure IGMP Snooping, highlight IGMP Snooping on the Multicasting Menu
and press Enter:
To configure IGMP Snooping, complete the following steps:
Toggle the Switch IGMP Snooping field to Enabled. Toggle the Querier State field
to the appropriate choice among Non-Querier, V1-Querier, and V2-Querier to
determine the version of IGMP that is used in your network. You can enter a value
between 1 and 255 for the Robustness Variable (default is 2). You can set the
Query Interval between 1 and 65500 seconds (default is 125 seconds). This sets
the time between IGMP queries. The Max Response enables a setting between 1
and 25 seconds (default is 10) and specifies the maximum amount of time available
before sending a response report. The Age Out timer is fixed at 260 seconds.
Highlight APPLY and press Enter to make the settings effective.
The user-changeable parameters in the switch are as follows:
Switch IGMP Snooping: <Disabled>
This field can be toggled using the Spacebar between Disabled and
Enabled. This is used to enable or disable IGMP Snooping, globally, on the
switch.
Chapter 6. Configuring the switch module through the Telnet interface
105