Forwarding; Class Of Service - IBM BladeCenter Installation And User Manual

Priority [128]
Fast STP <Disabled>
STP State <Enabled>

Forwarding

Highlight Forwarding on the main menu to access the following MAC Address
Forwarding window:
The Action field can be toggled between Add/Modify and Delete using the
Spacebar. Enter the VLAN ID in the VID field, the MAC address to be entered in
the forwarding table in the Unicast MAC Address field, and select either internal or
external ports in the Module field. Enter the port number in the Port field.
Highlight APPLY and press Enter to make the changes current. Use Save Changes
in the main menu to enter the changes into NVRAM.

Class of Service

The switch module enables you to customize class of service settings on the Class
of Service menu.
Select Class of Service on the main menu and press Enter. The following window
opens:
The spanning tree port priority can be set between 0 and 255. The lower
the priority, the greater the probability that the port will be chosen as the
root port.
Toggle between Enabled and Disabled. When the STP is turned on, a
change from link-down to link-up will trigger the STP. The STP will set the
port to the listening state. After the forward delay, the STP will set the port
to the learning state. After another forward delay, the STP will set the port
to the forwarding state. If the forward delay is 15 seconds, the port will take
30 seconds to forward packets. However, when Fast STP is Enabled on a
port, the port will only take 15 seconds from link-up to the time that it starts
forwarding packets. This is because enabling the Fast STP option will skip
the learning state, jumping directly to the forwarding state from the listening
state.
The Spanning Tree Protocol state for a selected port can either be Enabled
or Disabled.
Chapter 6. Configuring the switch module through the Telnet interface
101