Fitting The Lid; Pulse Function; Using The Food Processor - Russell Hobbs 18990 Instructions And Warranty

Fitting the Lid

1. Always fit the lid to the jug before using it.
2. Press well on the lid until the flanges are fitted well in the jug.
3. Put the cap into the hole in the lid and press it down to fit properly.
4. It is not a good idea to run the blender without the cap, especially if only solid ingredients
are used. They may be ejected through the hole when they hit the blades.
The Switch
1. Turn the speed control to the speed you want (1 = low, 2 = high).
2. Turn the speed control back to 0 or OFF to turn the motor off.
3. Generally, large quantities, thick mixes and a high ratio of solids to liquids suggest
longer timings and slower speeds. Smaller quantities, thinner mixes and more liquids
than solids suggest shorter timings and higher speeds.
Don't run the motor for more than 1 minute, or it may overheat. After 1 minute, switch off
4.
for at least 2 minutes, to let the motor cool.

Pulse Function

Turning the speed control anti-clockwise to PULSE will give you a short burst at
maximum speed, regardless of the current speed of the blades. The button is spring-
loaded. When you let go, it will return to OFF (0).
Finished
Turn the switch to OFF (0), wait until the blades have stopped moving before removing the
lid from the jug – or removing the jug from the motor unit. Hold the motor unit with one
hand, grasp the handle with the other hand, and then lift it off the motor unit. Lift the lid off
the jug.

Using the Food Processor

This section applies specifically to model 19000-56 Food Processor Combo.
1. Switch the appliance OFF (0) and unplug it.
2. Fit the spindle to the top of the motor unit.
3. Align the arrow on the bottom of the jug with the UNLOCK symbol on the motor unit.
4. Lower the jug on to the motor unit, then turn the jug to align the arrow with the LOCK