Roland VersaCamm SP-300V User Manual page 31

4.
Set the media clamps and close the front cover.
Set the media clamps.
Close the front cover.
The screen displays the printable width.
W 500mm
Important Note When Using the Media Clamps
Set the media clamps at the correct locations. If they are not set at the correct locations, the media may catch
or cause other problems that prevent successful printing.
As printing proceeds, the media may move to the left or right and touch or come loose from the media clamps.
After about 1 m (3 ft.) of media has been fed, check the positioning of the media clamps. If the media looks like
it may come loose from the media clamps, adjust the positioning of the media clamps.
When you cut off media while using the short media clamps, then depending on the media, it may come loose
from the media clamps. After you cut off the media, check to make sure that the media has not come loose
from the media clamps.
2-2 Loading and Cutting Off Media
Media clamp
Line up the edges of
the media with the
centers of the holes.
Chapter 2 Operation 29