Roland VersaCamm SP-300V User Manual page 120

*1
The length of printing or cutting is subject to the limitations of the program or driver.
*2
At Roland PET film, print travel: 1 m
Temperature: 25 C (77 F), humidity: 50%
*3
Not assured when the print heater or dryer is used.
*4
The following conditions must be satisfied:
Media type: 3M Scotchcal Mastercut Film
Roll media must be loaded on the shaft
[PREFEED] menu item must be set to [ENABLE]
Side margins: 25 mm or more for both the left and right margins
Front margin: 35 mm or more
Excluding stretching/contraction of the media
Range for assured repetition accuracy
Provided that media length is under 3000 mm
*5
Provided that media length is under 3000 mm
Temperature: 25 C (77 F)
Excluding possible shift caused by expansion/contraction of the media and/or by reloading the media
*6
Media type: Roland PET film
Data size: 1,000 mm in the media-feed direction, 736 mm in the carriage-movement direction
No lamination
Automatic detection of crop marks at 4 points when media is reloaded
During cutting, [PREFEED] menu item must be set to [ENABLE]
Temperature: 25 C (77 F)
Excludes the effects of slanted movement and of expansion and contraction of the media
*7
Warm-up is required after powerup. This may require 5 to 20 minutes, depending on the operating environment.
Depending on the ambient temperature and media width, the preset temperature fail to be reached.
*8
Operating environment
Humidity (%)
(no condensation) 80
55
35
0 15 20 27 32
(59) (68) (80.6) (89.6)
Temperature
118
Use in an operating environment
with this range.
C ( F)