Netdisk Wireless System; Equipment Setup - Ximeta NetDisk Wireless Access Point Router User Manual

NetDisk™ Wireless User Manual

3-8. NetDisk Wireless System

3-8-1. Equipment Setup

This function allows you to change the configuration of NetDisk Wireless through remote
management.
Remote Management
NOTE: Even though you input the port number as 0 (zero), NetDisk Wireless
recognizes the port number as 8888.
Non-Standard FTP Port :
IPSEC NAT Service
PPTP NAT Service
VoIP NAT Service
XIMETA, Inc
[Figure 3-21. Equipment Setup]
: Allows you to access NetDisk Wireless's Wireless Access Point
router function from a remote location via the Internet. Follow
steps below to enable Remote Management.
1) Click Equipment Setup at System
2) Make sure Enable is Selected (Default is Enable)
3) Input port number at the Port to Use box (Default is 8888)
When Default is Disabled, port number is 2121. You can Select
Enable and input the port number you wish to use.
: Enable or disable IPSEC Pass Through.
: Enable or disable PPTP Pass Through.
: Enable or disable VoIP Pass Through.
29
Network Direct Attached Storage / NDAS™
www.XIMETA.com