Assembly - Healthrider 8.5ex Crosstrainer HREL8806.1 User Manual

ASSEMBLY

To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included hex keys, assembly requires a Phillips screwdriver , an adjustable
wrench , and a rubber mallet .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. Note: Some small parts may have
been preassembled. If a part is not in the hardware kit, check to see if it has been preassembled.
Star Washer M4 x 13mm M6 Split M8 x 15mm x 4.5mm M8 Split Wave Washer
(98)–8
(100)–3 Washer (93)–2 Washer (88)–8
Washer (99)–4 Washer (72)–4
M4 x 16mm M4 x 16mm
Self-tapping Screw (86)–8
M10 x 20mm x M10 x 25mm M8 Nylon M10 Nylon
Screw (79)–16
1mm Washer Washer (94)–10 Locknut (96)–4 Locknut (97)–2
(81)–2
M8 x 16mm Patch
M6 x 35mm Phillips M8 x 42mm Bolt
Screw (95)–3
Screw (87)–8 (71)–4
M8 x 75mm Patch M10 x 20mm Patch M10 x 23mm Shoulder
Screw (107)–4 Screw (91)–10 Screw (80)–2
M10 x 78mm Patch Screw (90)–2
M10 x 62mm Patch Bolt (89)–2
5