Connecting The Wires; Figure 2-3 Audio And Alarm Pins; Table 2-1 Audio And Alarm Connector Pin Definitions - Honeywell EQUIP HD3MDIP User Manual

Connecting the Wires

Document 800-04132V1 Rev A
01/10
2. Pre-drill the holes as indicated on the template, using the recommended hole size for
the screws being used.
Note Other fasteners (preferably stainless steel) can be used, provided they are not
larger than the screw holes on the mounting template.
Connecting Audio and Alarms
1. Pull the wires through the ceiling or wall hole until you have at least 4 inches of wire.
2. Remove the green connector strip (see
and make all the necessary alarm and audio connections.
3. Connect a twisted pair (UTP) cable from each peripheral alarm contact to each alarm
input on the terminal block.
Figure 2-3 Audio and Alarm PINs
Power 1
Table 2-1 Audio and Alarm Connector PIN Definitions
PIN Definition
1 Audio In +
2 Audio In -
3 Audio Out +
4 Audio Out -
5 Alarm In +
6 Alarm In -
7 Alarm Out +
8 Alarm Out -
Connecting Audio
The network camera supports bi-directional audio. There are two supported voice band
channels that function in full duplex mode. The camera can transmit audio from the camera
to the client (PC) using any audio source that provides an industry standard line level input
(see the terminal strip as depicted in
HD3MDIP/X Network Camera Reference Guide
Figure 2-6 on page
2 3 4 5
Figure 2-6). The camera can also receive audio from
22) from the camera base
7
6 8
19