Trap Command Group - GE Digital Energy 1018959 Operating Manual

2.2.9 Trap command group

The trap command group allows to configure the trap sending functionality. With SNMP traps various
systems can be notified in case of UPS events and alarms.
Command Parameters
showtrap
sendtrap on | off
sendgetrap on | off
[X.X.X.X]
v1 | v2
addtraptgt
[community]
[port]
deltraptgt [X.X.X.X]
Modifications reserved
OPM_CNT_SNM_BAS_CRD_1GB_V014.doc
Description
Show detailed trap configuration
Enable/disable send trap [RFC1628] function
on Trap sending enabled
off Trap sending disabled
Enable/disable send trap [GE-MIB] function
on Trap sending enabled
off Trap sending disabled
NOTE: 3-ph version ONLY
Add a trap address
[X.X.X.X] IP-address of the trap target
v1 | v2 SNMP version
(optional – default: v1)
[community] community name
(optional – default: public)
[port] port to which the trap will be sent
(optional – default 162)
NOTE: Maximum 20 recipients can be defined.
Delete a trap address
[X.X.X.X] IP-address of the trap target
Page 22/69
Operating Manual SNMP/Web Adapter