Monitor Commands; Command Result Codes - GE VersaMax IC200SET001 User Manual

5

Monitor Commands

The following commands are available in the monitor mode. Many commands
have an IP address as an optional parameter (x.x.x.x). If it is given, the
command is applied to another VMSE with that IP address. If no IP address is
given, the command is executed locally.
All commands must be given in capital letters; only blanks (spaces) are
accepted between parameters.
Command
DL
SF x.x.x.x
VS x.x.x.x
GC x.x.x.x
SC x.x.x.x
PI x.x.x.x
AT
TT
NC
RS
SI x.x.x.x:n.n.n.n
QU

Command result codes:

0
1
2
8
9
5-2 VersaMax Serial to Ethernet Adapter User Manual
Description
Download firmware to the VMSE
Send firmware to VMSE with IP x.x.x.x
Query software header record (16-byte)
Get configuration as HEX records
Set configuration from HEX records
Check with Ping if x.x.x.x is alive and reachable
Show the VMSE's ARP table entries
Shows all the incoming and outgoing TCP connections (used
only with "monitor mode" from Telnet)
Shows the IP configuration of the VMSE
Resets the power on the VMSE
With this command, you can remotely assign an IP address to
another VMSE, where x.x.x.x is the new IP address and
n.n.n.n is the remote VMSE serial number written twice. For
example:
SI194.39.78.234:146.138.146.138
IP address = 194.39.78.234
Remote VMSE serial # (146-138) = 146.138.146.138
NOTE: Since this is obtained by sending broadcast packets,
this IP assignment cannot be done over the routers.
Quit - exit diagnostics mode
OK, no error
No answer from remote device
Cannot reach remote device or does not answer
Wrong parameter(s)
Invalid command
GFK-1852B