GE Digital Energy 1018959 Operating Manual page 51

Address Description
10X32 -
10X33 upsStatusEcomodeIsOn
10X34 upsStatusBatteryIsCharging
10X35 upsStatusBatteryIsDischarging
10X36 upsStatusAlarmIsActive
10X37 upsStatusRectifierIsOn
10X38 upsStatusStopOperation
10X39 upsStatusOnBypass
10X40 upsStatusMainsBypassOK
10X41 upsStatusMainsRectifierOK
10X42 upsStatusDetourIsOn
10X43 upsStatusAcousticAlarmIsOn
10X44 upsStatusServiceCheck
10X45 upsStatusInverterIsOn
10X46 upsStatusNotInParallel
10X47 upsStatusResetLoadOff
10X48 upsStatusLoadOff
10X49 upsStatusBoostMode
10X50 upsStatusBuckMode
10X51 upsStatusIemModeIsOn
10X52 upsStatus5thFilterIsOn
10X53 upsStatus11thFilterIsOn
10X54 upsStatus2ndRectifierBridgeIsOn
10X55 -
10X56 -
10X57 -
10X58 -
10X59 -
10X60 -
10X61 upsGlobalParallelValues
10X62 -
10X63 -
10X64 -
NOTE: Registers 10X26 – 10X31 hold different contents in 1-ph and 3-ph UPS.
Registers 10X33 – 10X64 are only available on 3-ph UPS.
NOTE: GT Series 5-10kVA UL UPSs are 2-ph systems.
In this case, the L-L voltage is mapped to Line3 Voltage registers.
Modifications reserved
OPM_CNT_SNM_BAS_CRD_1GB_V014.doc
Notes
Not Used (Reserved)
Ecomode is ON.
Battery is being charged.
The UPS is drawing power from the batteries. Identical to
upsAlarmOnBattery.
UPS has a general fault. Identical to upsAlarmGeneralFault.
Rectified is ON.
The remaining battery run time is less than or equal to
upsConfigLowBattTime or any other condition exist, such
that the output will be disconnected in a short time.
The Bypass is presently engaged on the UPS. Identical to
upsAlarmOnBypass.
All input conditions on the Bypass are OK. Reciprocal to
upsAlarmBypassBad.
All input conditions on the rectifier are OK. Reciprocal to
upsAlarmInputBad.
The manual deviation is on.
The acoustic alarm is on, as a consequence of a new fault.
A general maintenance or a specific UPS component check
is required.
The Inverter is switched on.
The UPS belongs to a parallel system but does not supply
the load (disconnected).
The load is not supplied and special action has to be
performed prior to be able to restart.
The load is not supplied
Boost mode
Buck mode
IEM (Intelligent Energy Management) mode is active
5 order harmonic filter is inserted
th
(SCR-based rectifier only)
11 order harmonic filter is inserted
th
(SCR-based rectifier only)
For units featuring two separate rectifier bridges (typically
large 3-ph UPSs), the 2
nd
Reserved for future enhancements
Reserved for future enhancements
Reserved for future enhancements
Reserved for future enhancements
Reserved for future enhancements
Reserved for future enhancements
The set of registers pertains to the whole parallel system
rather than specific UPS in the system.
Reserved for future enhancements
Reserved for future enhancements
Reserved for future enhancements
rectifier bridge is on.
Operating Manual SNMP/Web Adapter
Page 51/69