Table of Contents
Advertisement
10.3.1 WLAN Basic Parameters
To configure WLAN basic Parameters go to BASIC/WLAN CONFIGURATIION/BASIC
PARAMETERS, enter values for the required parameters and then press the Y key
when prompted by the following message Do You Wish To Submit These Values
[Y/N]. The WLAN Basic Parameters menu includes the parameters listed below:
IP Address
Subnet Mask
MAC Address
SSID
Channel
Enter the IP address for the WLAN interface
Enter a subnet mask for the WLAN interface
Enter a MAC address to limit access to the router (only packets destined for
this MAC address will be accepted by the router).
The SSID should match with your client adapters. The SSID
(Service Set ID) allows you to uniquely identify your Access Point in the radio
environment.
The channel should match with client adapters. The Direct
Sequence Spread Spectrum (DSSS) channel number is an identifier for the
frequency on which your WLAN connectivity is enabled in the WLAN
network. Although the configurable DSSS channel number range is from 1 up
to 13, restrictions apply depending on the country where the Wireless ADSL-
Router is used: FCC: channels 1 to 11 ETSI: channels 1 to 13.
77
Advertisement
Table of Contents
