Chapter 10 Console Management
This section of the manual deals with console management of the router.
10.1
Hardware connection
In order to manage your device through the console port you will need to use a
straight-through cable with an RJ-45 connector to attach to the modem, and a
female RS-232 connector to connect to the serial port on a PC. The PC must be
equipped with a VT-100 emulation program, such as HyperTerminal 5 or Telix.
10.2
Access by Console
For access by console, the console PC should be installed with a standard VT-100
emulation program, such as HyperTerminal 5 or Telix. The following steps describe
how to establish the console session.
Step 1
Start a standard VT-100 program such as HyperTerminal (Ver. 5
is recommended), or Telix in the local terminal; and select an
open com port.
Step 2
Enter the following port settings:
Baud rate: 9600
Data bits: 8
Parity: none
Stop bit: 1
Flow control: none
74