Table of Contents
Advertisement
ADD AN ENTRY
To set up PPPoE, click PPPoE, configure the common fields on the top of the page, as
well as the following fields. At the bottom of the screen, click the Add button to add
the entry. In addition, If the PPPoE mode is set to auto, clicking the MANUAL MODE
Enable button will effectively disable auto mode, and require the user to reconnect a
terminated PPPoE session by clicking the MANUAL MODE Trigger button.
Subsequently, to return to Auto-mode, click on the MANUAL MODE Disable button,
which will appear in place of the MANUAL MODE Enable button.
User name/Password: used for the remote customers to login during dialup.
Mode: Direct and Auto. If the mode is set to AUTO, the PPPoE negotiation
automatically starts when the system identifies any traffic required to be
transferred on the link. When DIRECT is selected the PPPoE negotiation is started
manually using the "pppoestart" command. The default is DIRECT.
Idle Timeout: defines the period of idle time (minutes) after which the PPPoE
link will be terminated.
Authentication: defines the authentication code: PAP, and CHAP
Enable DHCP Server: enables the DHCP server. This field is automatically
checked when PPPoE is selected. Deselect the field to disable the DHCP server.
The DHCP server dynamically allocates network addresses and delivers
configuration parameters to hosts.
MODIFY AN ENTRY
To modify an entry, complete the following steps:
STEP 1: Select the entry from the Current ATM PVC List, at the bottom of the
WAN Setup page. The current values of the selected entry will display in the
upper section of the page.
STEP 2: Change the parameters.
STEP 3: Click Modify.
DELETE AN ENTRY
To delete an entry, Select it from the Current ATM PVC List, at the bottom of the
WAN Setup page, and click the Delete button.
16
Advertisement
Table of Contents
