Table of Contents
Advertisement
PROCISE 7.3 Surround Sound Processor
Compression
52 • PROCISE 7.3 Surround Sound Processor: PSPHD
If desired, it is possible to watch an HDMI video source while listening to a
non-HDMI audio source (audio breakaway).
To listen to a non-HDMI audio source that is different from the selected HDMI
video source:
1.
Select an HDMI video source as described on the previous page.
2.
Turn the selection knob to the desired audio source.
NOTE: The alternative audio source cannot be from an HDMI input.
3.
Press the selection knob to select the displayed source.
4.
Press HOME to return to the Home screen.
If after watching an HDMI video source it is desired to listen to an audio source
without video, first turn off the HDMI video source by selecting "NONE". Then
select the desired audio source.
Surround Sound Decoding Mode Selection
Surround sound decoding modes can be applied to an incoming audio signal. To
select a decoding mode:
1.
Press MODE.
2.
Turn the selection knob until the desired decoding mode is displayed.
3.
Press the selection knob to confirm the selection.
NOTE: Some signals are not compatible with all decoding modes.
4.
Press HOME to return to the Home screen.
Setup
The PSPHD can be set to apply compression, Audyssey Dynamic EQ, and Audyssey
MultEQ XT to an incoming signal. The PSPHD can also be set to adjust the bass and
treble levels of the incoming audio signal. Additionally, the PSPHD can bypass any
adjustments (Direct mode).
NOTE: Until Audyssey calibration has been performed, the PSPHD front panel
shows a message every few seconds indicating that the system should be calibrated.
The PSPHD can apply Audyssey Dynamic Volume Compression or Dolby/DTS
DRC Compression to the audio signal.
NOTE: The Audyssey MultEQ function must be enabled prior to enabling the
Audyssey Dynamic Volume Compression. For information on enabling Audyssey
MultEQ XT, refer to "Audyssey MultEQ XT" on page 54.
Crestron PSPHD
Operations Guide – DOC. 6837C
Advertisement
Table of Contents
