Shimano FlightDeck SC-7900 Service Instructions Manual page 22

10. Stopwatch Function/Recording Traveling Data
■ Starting and stopping the stopwatch counter
Starting and stopping the stopwatch counter can be switched between
manual and automatic operation.
(For details on the setting method, refer to page 32.)
Automatic setting
(1) Switch the main unit display to normal
mode.
• For the automatic setting, "AT" will appear
in the LCD.
(2) Press the set button to switch the counter to standby. "stw" will
illuminate in the information display.
(3) The counter will start when a speed signal is received.
"stw" will flash in the information display.
(4) The counter will stop approximately 4 seconds after the speed signal
stops being received.
"stw" will illuminate in the information display.
* For the manual setting, the stopwatch will not stop even when the speed
signal stops being received, and data will still continue to be recorded.
Manual setting
(1) Switch the main unit display to normal mode.
(2) Press the set button (stopwatch button) to start the stopwatch counter.
"stw" will flash in the information display.
(3) When you press the stopwatch button once
more, the counter will stop.
"stw" will illuminate in the information
display.
40
■ Resetting the counter and recording traveling data
The traveling data is recorded at the same time the stopwatch counter is
reset.
(1) Stop the stopwatch counter.
(2) Hold down the set button (stopwatch button) for 2 seconds or more.
(3) The stopwatch counter will then be reset to
zero.
"stw" will disappear from the information
display.
• If "Data recording" is set to ON, traveling data will be recorded in the
main unit.
• "REC" will appear in the LCD while
traveling data is being recorded.
* For details on the setting method, refer to
page 32.
41