Shimano FlightDeck SC-7900 Service Instructions Manual page 16

VERSION mode
This mode is used for displaying the software
version and network ID for the main unit.
(1) Select "VERSION" in the main menu.
(2) Press the set button.
(3) The confirmation screen for the firmware
version and the network ID will be displayed.
If you press the set button, the screen will
return to the main menu.
SETTING mode
(1) Select "SETTING" in the main menu.
(2) Press the set button.
(3) The Setting menu will be displayed.
■ Bike settings
(1) Select "BIKE" from the Setting menu.
(2) Press the set button.
(3) The odometer distance input screen will be displayed.
Entering the odometer distance
You can enter your desired cumulative distance.
(1) Press the set button to enable the odometer
distance to be entered.
The odometer distance display will be
highlighted.
(2) Press the select button, button A or button B
to enter the desired value.
(3) Press the set button to confirm the value
entered.
(4) If you press the select button or button A, the
display will change to the next item.
28
Entering the tire circumference
(Applicable tire circumferences: Refer to page 341.)
(1) Press the set button to enable the tire
circumference to be entered.
The tire circumference display will be
highlighted.
(2) Press the select button, button A or button B to
enter the desired value.
(3) Press the set button to confirm the value entered.
(4) If you press the select button or button A, the display will change to
the next item. If you press button B, the screen will return to the
previous setting item.
Selecting the number of chainrings
(1) Press the set button to enable the number of
chainrings to be changed.The chainring display
will be highlighted.
(2) Press the select button, button A or button B to
enter the desired number of chainrings.
• SINGLE
(3) Press the set button to confirm the number of chainrings selected.
(4) If you press the select button or button A, the display will change to
the next item. If you press button B, the screen will return to the
previous setting item.
(km) Selecting the number of chainring teeth
(1) Press the set button to enable the number of
chainring teeth to be changed.
The number of teeth for the largest chainring
will be highlighted.
(2) Press the select button, button A or button B to
enter the desired number of chainring teeth.
(3) Press the set button to confirm the number of teeth selected.
(mile)
The number of teeth for the next chainring will be highlighted.
(4) Repeat steps (2) and (3) to set the number of teeth for each chainring.
* Measure the tire circumference by inflating
the tire to the correct pressure, making a
Turn forward
mark on the ground where the tire touches
it, then turning the wheel one full
revolution with you riding the bicycle, and
then measuring the distance between the
two points.
Tire circumference
• DOUBLE • TRIPLE
29