Powerline Network - Siemens Gigaset Powerline Adapter 200 User Manual

For detailed information on IP addresses please see the chapter "Defining IP addresses"
on page 26.
ì
Select Settings – Local Network.
ì
If you want to assign the Gigaset Powerline Adapter 200 a different IP address, enter
it in the fields next to IP address.
ì
Enter a Subnet mask in the appropriate fields.
ì
The parameter Default gateway is only used in more complex network scenarios. If
applicable, enter the IP address of the Default gateway in your network.
ì
Click OK to apply your settings.
Please bear in mind:
u
If you change the IP address and then forget it, you can get it again using the GetIP
procedure (see page 37).

Powerline Network

The Gigaset Powerline Adapter 200 can be operated in two modes. One device in a Pow-
erline network must be in operating mode Access point, the other(s) in operating mode
Automatic. Automatic enables the adapter to be set as an access point or end point as
appropriate. There can be only one access point in the Powerline network. One of the
supplied Gigaset Powerline Adapter 200 is configured as the access point by default.
You can recognise it by an AP in the bottom line of the label (page 11).
In the Powerline Network screen, you can change the operating mode of your Gigaset
Powerline Adapter 200 and the current network ID.
Configuration
19