Elements In The User Interface; Settings; Lan Configuration - Siemens Gigaset Powerline Adapter 200 User Manual

Configuration
Remember:
Please bear in mind that a reset will restore all the settings to the factory configura-
tion. The preset password will be active again.

Elements in the user interface

The user interface screens contain the following buttons:
OK Accepts the settings you have made to the Gigaset Powerline
Adapter 200 configuration.
Cancel Deletes all the entries in a screen since the last time you clicked OK.
This button is not available for the initial configuration of the device.
Other buttons may be visible depending on the function in question. These are
described in the relevant sections.

Settings

On the Settings menu, you can configure all the options for the
Gigaset Powerline Adapter 200. The following table shows the options in the menu.
Menu
Local Network
Powerline Network Here you can change the operating mode and network ID of
Administration

LAN configuration

LAN configuration is used to define the IP address of the Gigaset Powerline Adapter 200.
This setting is preset on delivery.
The preset IP addresses are:
192.168.2.10 for the access point in a Gigaset Powerline Adapter 200 Duo package
192.168.2.11 for the second Powerline adapter in a Duo package
192.168.2.12 for a single Gigaset Powerline Adapter 200 supplied as single decvice
The IP address does not have any influence on the functionality of the powerline net-
work. But nevertheless, each IP address in the network must be unique. You need the IP
address only to configure the Gigaset Powerline Adapter 200 so it should be reachable
by your PC.
The IP address must be changed if you add a further Powerline adapter to your network.
18
Description
Here you can change the IP address of the Gigaset Powerline
Adapter 200 (see below).
your Gigaset Powerline Adapter 200, as well as the encryption
settings (see page 19).
Here you can make or change various system settings, e. g.
assign a password or reboot the system (see page 21).