Fujitsu SERVIS IP-KVM User Manual page 28

2.2 Set the IP Address (For Initial Installation)
5. The following set up menu is displayed.
2
DHCP is enabled as the factory setting. Log on this product and be sure to specify
the fixed IP address if you operate the host server from a remote location
extended periods of time.
6. To assign an IP address, disable the DHCP. The "Choice:" prompt is displayed
and enter "d".
7. The following is displayed and DHCP is disabled. Press the [Enter] key.
SERVIS IP-KVM
16
1p Converter
User's Guide
---------------------------
SERVIS IP-KVM Network Setup
---------------------------
NOTE: This interface is used to set network parameters and perform
certain recovery procedures, but the majority of setup and
configuration can only be done using the web interface.
Primary Ethernet Port (LAN)
DHCP is enabled. Current lease information:
IP Address: 192.168.0.2
Netmask: 255.255.255.0
Gateway: Disabled
Broadcast: 192.168.0.255
Machine name: noname
Default Gateway: <none> (DHCP: 192.168.0.1)
Commands (press one key, then Enter):
D - Disable DHCP, and use fixed IP address.
* I - Set IP address.
* N - Set netmask.
* G - Set network gateway.
* B - Set broadcast address (optional).
M - Change machine name (DHCP client name).
H - Reset/disable firewall, TCP ports, SNMP, RADIUS.
F - Reset everything to factory defaults.
S - Change system admin password.
P - Send ICMP ping packets (testing purposes).
? - Show TCP/IP ports and servers enabled.
V - Show Firmware Information.
R - Revert to current settings (undo changes).
W - Commit changes to configuration.
Q - Logout.
* -> These values ignored due to DHCP.
Choice:
Choice: d
Enter↵
DHCP has been disabled.
Press Enter to continue...
(00:0e:00:ee:04:03)
Enter↵