Ricoh Aficio MP 2510 Operating Instructions Manual page 155

Programming a password
This section describes how to program a password for the Personal Box.
A
Press [Password].
B
Enter a password, and then press [OK].
If you make a mistake, press [Clear] or the {Clear/Stop} key before pressing
[OK], and then try again.
C
Re-enter the password, and then press [OK].
To change the password after pressing [OK], press [Change] and repeat steps
C
and , or press [Cancel] and repeat from step
D
Press [OK].
Programming an End Receiver
This section describes how to program an End Receiver of the Personal Box.
A
Press [Receiver].
B
Select a destination using the destination list, and then press [OK].
Press the key shown on the right side of the screen to switch the destination
among fax number, Internet Fax address and IP-Fax address.
A
.
Box Settings
4
B
147