Cisco 2500 Series User Manual page 10

IP Camera Physical Details
Figure 1-2
Figure 1-2
1 Antenna connectors
(wireless model only)
2
Reset button
3 Network LED (amber)
4
LAN port
5 PoE LED (green)
Cisco Video Surveillance 2500 Series IP Camera User Guide
1-4
and the table that follows describe the items on the rear of the IP camera.
Rear of IP Camera
Antennas screw into these connectors and are used for
communication in wireless networks.
Recessed button that reboots the IP camera or resets it to a default
state. You can use a pin or paper clip to depress it. It can be used
any time that the IP camera is on and can have various effects, as
described in the
Indicates information about the network connections as follows:
•
•
•
Accepts a standard LAN cable to connect the IP camera to a
10/100BASETrouter, or switch.
On the wireless IP camera model, attaching a LAN cable disables
the wireless interface. Only one interface, wired or wireless, can be
active at a time.
Connect or disconnect the LAN cable only when the IP camera is
powered off. Doing so while the IP camera is powered on does not
switch the interface between wired and wireless.
Indicates information about PoE as follows:
•
•
"Resetting the IP Camera" section on page
On—LAN or wireless connection is detected
Off—LAN or wireless connection is not detected
Blinking—Data is being transmitted or received via the LAN
or wireless connection
On—PoE connection is detected
Off—PoE connection is not detected
Chapter 1 Overview
2-9.
OL-19273-02