Ptz (Rs-485) Window - Cisco 2500 Series User Manual

Applications Windows

PTZ (RS-485) Window

The PTZ (RS-485) window allows you to enable pan, tilt, zoom (PTZ) functions for the IP camera. These
functions require that the IP camera be installed with a motorized zoom/focus lens in a pan/tilt mount
that supports the Pelco D protocol.
This window also provides options for configuring a patrol sequence, or sequence, for the IP camera. A
sequence consists of up to 20 steps, each of which causes the camera to move to a designated position
and remain in the position for 30 seconds.
To display the PTZ (RS-485) window, access the configuration windows as described in the
the IP Camera Windows" section on page
If you change any options in the PTZ (RS-485) window, you must click Save to save the changes. To
discard the changes, click Cancel before clicking Save. These buttons appear at the bottom of the
window. You may need to scroll down to see them.
Table 3-20
Table 3-20
Option
Enable External PTZ
Port Settings
Baud Rate
Data Bits
Parity
Stop Bits
Address
Preset Position
Note
Set Preset Position
Cisco Video Surveillance 2500 Series IP Camera User Guide
3-36
describes the options in the PTZ (RS-485) window.
PTZ (RS-485) Window Options
Description
Check this check box to enable configuration of the PTZ settings.
Choose the Baud rate value that is configured on the device that controls the
PTZ functions of the IP camera.
Choose the data bits value that is configured on the device that controls the
PTZ functions of the IP camera.
Choose the parity value that is configured on the device that controls the PTZ
functions of the IP camera.
Choose the stop bits value that is configured on the device that controls the
PTZ functions of the IP camera.
Enter the logical address of the external PTZ device.
To determine this address, refer to the documentation for the device.
The Preset Position option appears if you check the Enable External PTZ check box.
Click the Set Preset Position button to define a preset position of the IP
camera.
When you click this button, the Set Pan/Tilt window appears. For detailed
information about this window, see the
on page
Chapter 3
2-6, click Applications, then click PTZ (RS-485).
3-37.
Configuring and Managing the IP Camera
"Accessing
"Preset Positions Window" section
OL-19273-02