Cisco 2500 Series User Manual page 35

Chapter 3 Configuring and Managing the IP Camera
Table 3-4
Option
Enable Multicast
Video Address
Video Port
Audio Address
Audio Port
Time to Live
QoS
Enable QoS Mode
Enable WMM (802.11e
QoS)
DSCP
OL-19273-02
Advanced Setup Window Options (continued)
Description
Check this check box to send video and audio data as a multicast stream.
When multicast is enabled, the IP camera sends video and audio to the
multicast addresses that you designate. Multicast enables multiple devices to
receive the video signal from the IP camera simultaneously.
Appears if you enabled multicast. Enter the multicast IP address on which
the IP camera sends a video stream.
The default value is 224.2.0.1.
Appears if you enabled multicast. Enter the port on which the IP camera
sends a multicast video stream.
Valid values are even numbers 1024 through 65534. The default value is
2240.
Appears if you enabled multicast. Enter the multicast IP address on which
the IP camera sends an audio stream.
The default value is 224.2.0.1.
Appears if you enabled multicast. Enter the port on which the IP camera
sends a multicast audio stream.
Valid values are even numbers 1024 through 65534. The default value is
2242.
Appears if you enabled multicast. Enter the number of hops, which specifies
the number of network devices that an audio-video stream can pass before
arriving at its destination or being dropped.
Valid values are 1 through 255. The default value is 16.
Check this check box and click the Audio, Video, or Both radio button to
enable Quality of Service (QoS) for audio streams, video streams, or both
streams.
QOS applies to Layer 3 only, and is applied to ASF and RTP video
Note
streams. When QOS is applied to an ASF video stream, DSCP values
are not distinguished between audio and video streams because they
are applied to the same stream. When QOS is applied to an RTP
video stream, DSCP values are distinguished between audio and
video streams because they are applied to different streams.
Applies to wireless IP camera only. Check this check box to enable wireless
multimedia extensions for 802.11e QoS, which provides basic QoS features
for the wireless IP camera.
If you enable QoS, enter the Differentiated Services Code Point (DSCP) to
be used to process QoS packets.
The default value is 12.
Cisco Video Surveillance 2500 Series IP Camera User Guide
Setup Windows
3-13