Adjusting Back Focus On The Ip Camera; Powering The Ip Camera On Or Off - Cisco 2500 Series User Manual

Adjusting Back Focus on the IP Camera

Adjusting Back Focus on the IP Camera
To obtain the sharpest image from the camera, you may need to adjust its back focus. This adjustment is
useful if the focus control on a lens does not allow you to obtain a sharp enough image.
To adjust the back focus, perform the following steps while viewing video from the camera. For
information about viewing video, see
Procedure
Step 1 With a lens attached to the IP camera, use the 0.9 mm Allen wrench that is supplied with the IP camera
to loosen the focus ring hex screw.
This screw is on the bottom of the camera just behind the focus ring.
Step 2 Adjust the back focus by aiming the IP camera at an object that is at least 15 feet (4.5 meters) away and
rotating the focus ring to obtain a clear image as follows:
•
•
Use the Allen wrench to tighten the focus ring hex screw.
Step 3
1
2
3
4
5
6

Powering the IP Camera On or Off

The IP camera does not include an on/off switch. You power it on or off by connecting it to or
disconnecting it from a power source. When you power off the IP camera, it retains configuration
information.
To power on the IP camera, take either of these actions:
•
•
To power off the IP camera, take either of these actions:
•
•
Cisco Video Surveillance 2500 Series IP Camera User Guide
2-8
For a variable-focus lens, obtain a sharp picture in both wide-angle and telephoto positions.
For a zoom lens, ensure that the object of interest remains in focus throughout the entire zoom range
of the lens.
Back focus hex screw
Panning lock screw
Analog video output port
Zoom lock screw
Focus lock screw
Tilt lock screws
Use an STP category 5 or higher network cable to connect the IP camera to a network switch that
provides 802.3af compliant PoE
Use the appropriate power adapter to connect the IP camera to a wall outlet
If the IP camera is receiving PoE, disconnect the network cable
If the IP camera is receiving power through the power adapter, unplug the adapter from the wall or
disconnect it from the camera
Chapter 4, "Viewing Live Video."
Chapter 2 Getting Started
OL-19273-02