Message Waiting Light On [Phdn/Mw] - Toshiba 2000 series User Manual

Message Waiting ––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
3. After receiving the
message(s), place the
handset on hook.
To cancel the Msg light

Press
handset.
...or [DN] +
cancel the light. This
must be done for each
message recorded.

Message Waiting Light on [PhDN/MW]

To respond to [PhDN/MW]
1. Press the flashing red
[PhDN/MW] LED.
2. After receiving the
message, press
...or place the handset
on-hook.
To cancel [PhDN/MW]
1. Press [PhDN].
7
2. Enter
"$
3. Press
48
If the Msg LED continues to flash, you have more messages—
repeat the Steps to retrieve them. Voice mail devices may
cancel the indication after a short delay.
and lift the Your Msg LED turns OFF when the called party answers.
Note The called party must answer—by either going off-
hook or by pressing
7
to
cancelled automatically.
Your Msg LED turns OFF without calling the telephone or VM
device.
Your phone rings the station or voice mail device that left the
message. If the called party or VM device answers, the
message waiting indication is cancelled automatically. If there
is no answer, hang up and try at a later time. The red
[PhDN/MW] LED on your phone continues to flash.
If you have more messages, the red [PhDN/MW] LED
"$
continues to flash. To answer the next message, repeat this
procedure.
You hear a steady dial tone.
. The dial tone stops.
. The [PhDN/MW] LED turns OFF, indicating that the message
has been canceled.
"$
—for the indication to be
Strata DK Digital Telephone