Speed Dial Pause And Flash Storage - Toshiba 2000 series User Manual

––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Table 7 Feature Access Codes (continued)
4
Pickup any ringing CO line (new call only)
Pickup Station Page or Ringing Door Phone
4
Pickup External Page
Pickup Line on Hold (lines 1~99)
Pickup Line on Hold (lines 100~200)
1. These codes can be used during a CO line call.
2. Background music speakers can only be turned ON/OFF from Station 200.
3. XXX = Auto Park Orbit 9 9 9 (access the next available park orbit), or General Park Zones
900~919, or [PDN] on which the call should be parked. Only use 999 with LCD telephones.
4. This feature will hold an existing call when the button is pressed. If the button is pressed
when not on a call, pickup or page will still be accessed. These codes can be used during a
CO line call.
5. After pressing the feature button, the user dials the line number (01~99) to pickup the line.
6. After pressing the feature number, the user dials the line number (100~200) to pickup the
line.

Speed Dial Pause and Flash Storage

Some Speed Dial numbers may require a pause (long or regular) or hookflash be included
(e.g., tone delay requires a pause at the beginning of a Speed Dial number).
Hookflash
The
flash signal only if
as a flexible button on the
telephone. The flash signal
is 0.5 or 2 seconds long (set
in system programming) and
is displayed on the LCD as
" ".
F-
Press
...or enter the hookflash
dial code (
).
Features
Features
5
6
button stores a The pause is either 1.5 or 3
seconds (set in system
is programmed programming). The LCD
displays "
Press
...or if
telephone, press
to store a pause.
+
Feature Access Code Sequence


+ [PDN] +


4
+ [PDN] +


+ [PDN] +
 
[PDN] + +
 
[PDN] + +
Regular Pause
Ten-second pause, which
can be entered anywhere in
the Speed Dial number. The
". LCD displays "
P-
is not on the
Speed Dial—Advanced Features
%
"
"
&%%
( )
&!
( )
Long Pause
".
L-
Press
.
63