Flexible Buttons - Toshiba 2000 series User Manual

––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Table 1 Fixed Button Definitions (continued)
Button

(Speaker)



Flexible Buttons

All flexible buttons must be programmed for your telephone in system programming and vary
for individual telephones. If a button does not appear on your display or telephone keystrip
label, see your System Administrator for button assignments.
Line Buttons
You may have buttons designated as
directly access outside Central Office (CO) lines.
available CO Lines from a group of lines appearing under one button.
If your telephone does not have a
outside CO lines, you can use access codes. For a listing of these codes, see
on Page 107.
Directory Number [DN] Buttons
The [DN] buttons consist of: [PDNs], [SDNs], and [PhDNs]. They are used to initiate or
answer a call and are known as your extension or intercom number(s). You can have multiple
[DN] buttons on your telephone (see
telephone, [SDNs].
Incoming calls ring your telephone's [PDNs] from the top down. For example, incoming calls
to Station 10's [PDNs] first ring the "10-1" button, then "10-2," and finally "10-3." Your
[PDN] is considered busy only when all of the [PDNs] are being used by your telephone or
other telephones, and/or when your telephone is on any type of CO Line or [DN] call.
The Grand Tour
Press to toggle the speaker ON/OFF. The LED indicates the status of the
speaker.
Notes

must be pressed and held down when switching from Handset to
Speakerphone mode.
Also selects a line or the internal [PDN] if programmed for auto preference
in system programming. Can be used to disconnect on-hook
speakerphone calls.
Press to adjust volume levels (see
 
and/or
      
or
Figure 2), including [DNs] belonging to another
Definitions
"Volume Controls" on Page
    
which enable you to
    
enables you to access
button and you want to access
Buttons
10).
"Access Codes"
5