Dtmf Tone Dialing With * And - Toshiba 2000 series User Manual

–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
To call/monitor a door phone
1. With the handset off-
hook, press a [DN].
2. Dial the [DN] for the
desired door location.
To call from a door phone
1. Press the door phone
button and then
release it.
2. When answered,
speak at a normal
voice level in the
direction of the door
phone.

DTMF Tone Dialing with * and #

You may have to send
device or computer output service. DTMF tones are automatically enabled on stations with
" # 
This feature disables the Speed Dial feature during the call. Speed Dial is restored when you
complete the call or place it on hold.


To output and
While on an outside call, press
digits ~
you require such output.
Features
You hear dial tone and the LED flashes green (in-use).
If you have an LCD telephone, see
A two-way talk-path exists between your telephone and the
called door phone. You can audibly monitor the area around the
door phone.
Note
You hear a distinctive ringing tone—one or five times (set in
system programming).


and DTMF tones to some devices or services, such as a voice mail
" # 
. If you do not have
DTMF tones on a telephone without a


7
for the duration of the call. This procedure must be repeated on each call where
Door phone [DNs] can be stored on
"Feature Access Codes" on Page
, you must first dial
" # 
, then . You can now output
DTMF Tone Dialing with * and #
Table 6 for the [DN].
"#
buttons. See
61.


, to enable these tones.
button


and , DTMF tones, and
43