Bypassing Protection Zones - ADEMCO VISTA-20SE User Manual

BYPASSING PROTECTION ZONES

Using the 6 This key is used when you want to arm your system with one or more zones
intentionally unprotected. Bypassed zones are unprotected and will not cause an alarm
BYPASS Key
when violated while your system is armed. All bypasses are removed when an OFF
sequence (security code plus OFF) is performed. Bypasses are also removed if the
arming procedure that follows the bypass command is not successful.
The system will not allow fire zones to be bypassed.
To bypass zones, the system must be disarmed first.
1.
(Security Code)
2.
(Zone Numbers)
3. BYPASS 07 F RONT
UPST AIRS BE DROOM
Typical bypass message
4.
DISARME D BYPASS
RE ADY T O ARM
BYPASS
+ 6 ENTER SECURITY CODE THEN PRESS BYPASS
Example: 7 2 9 6 then press the BYPASS key.
ENTER ZONE NUMBERS
Enter the zone number(s) for the zones to be bypassed
(e.g., 01, 02, 03, etc.).
Important! All single-digit numbers must be preceded
by a zero (for example, enter 01 for zone 1).
WAIT
The keypad will display the word BYPASS along with
each bypassed zone number. Wait for these zones to
be displayed, to be sure that intended zones are
bypassed.
ARM AS USUAL
Arm the system as usual when the keypad displays the
"Ready " message.
– 21 –