Entry/Exit Delays; General Information - ADEMCO VISTA-20SE User Manual

ENTRY/EXIT DELAYS

General
Your system has preset time delays, known as exit delay and entry delay. Whenever
Information
you arm your system, exit delay gives you time to leave through the designated exit
door without setting off an alarm. Exit delay begins immediately after entering any
arming command, and applies to all modes of arming protection. If programmed, a
slow beeping will sound throughout the exit delay period.
Entry Delays give you time to disarm the system when you re-enter through the
designated entrance door. But you must disarm the system before the entry delay
period ends, or an alarm will occur. The keypad beeps during the entry delay period,
reminding you to disarm the system. There are two entry delays (if programmed). The
first is for your primary entrance and the second can be used for a secondary
entrance, where a longer delay is required to walk to the keypad to disarm the system.
You can also arm the system with no entry delay at all by using either INSTANT or
MAXIMUM arming modes. These modes provide greater security while on the
premises or while away for extended periods of time.
See your installer for your delay times.
Partition 1
Partition 2
Exit Delay: seconds
Exit Delay: seconds
– 7 –
Entry Delay 1: seconds
Entry Delay 2: seconds
Entry Delay 1: seconds
Entry Delay 2: seconds