Using Device Commands - ADEMCO VISTA-20SE User Manual

USING DEVICE COMMANDS

General Your system may be set up so that certain lights or other devices can be turned on or
Information off by using the device command from the keypad. Ask your installer if this has been
done in your system. If programmed for your system, some devices may activate
automatically upon certain system conditions. In this case, the following commands
can be used to override the device activation. See your installer for a full explanation of
this feature.
To activate devices ENTER SECURITY CODE THEN PRESS # + 7 + DEVICE NUMBER
(Security Code)
Example: 7 2 9 6 then
device you wish to activate. See your installer for device numbers assigned for your system.
To deactivate
ENTER SECURITY CODE THEN PRESS # + 8 + DEVICE NUMBER
devices
(Security Code)
Example: 7 2 9 6 then
device you wish to deactivate. See your installer for device numbers assigned for your system.
Device
1
2
3
4
+ # + 7 +
(Device Number)
press #, then press 7, then enter the number representing the
+ # + 8 +
(Device Number)
press #, then press 8, then enter the number representing the
Description
– 25 –
Device Description
5
6
7
8