Maintenance - Binatone NWT-920 Instruction Manual

Nut maker
Hide thumbs Also See for NWT-920:
Table of Contents

Advertisement

Available languages

Available languages

INSTRUCTIONS FOR USE
3.
When appliance is ready, open it, oil the panels
or other cooking fat. Fill the each of 24 parts of the lower panel
with a half tea-spoon of dough.
4.
Carefully lower the appliance lid pushing it lightly, and fix the
latch (3).
Attention! Do not try to close the latch until the cover is not
pressed tightly to each other, as this may cause damage
to the latch.
Your nut patties will be ready in 6-7 minutes. Open your nut maker
and gently take the patties off using a wooden (or heat-resisting
plastic) spatula. To avoid damaging the non-stick coating, never
use metallic objects (fork, knife) or any other sharp objects.
5.
If your nut patties are not brown enough, repeat point 4 once
again. Watch the nut maker closely to avoid patties burning.
6.
To switch the nut maker off just unplug it.
Warning: after use, always unplug the appliance.
For your convenience, the nut maker can be stored vertically.

MAINTENANCE

hard materials (metallic sponge, abrasive materials, etc.) or you
will damage the surface.
Warning: do not wash the panels under running water,
because it may lead to an electric fault in the appliance
wiring. If water got under the panels, set the appliance
upside down and let it dry out.
4.
Clean your nut maker after each use, do not let the burnt crumbs
accumulate on the panels (5).
5.
Before putting your appliance away for storage, unplug it and
let it cool completely. After that put the nut maker into a box and
store in a safe, dry place out of reach of children. Check that the
appliance and its power cord are not under pressure from heavy
or sharp objects.
1.
Place your nut maker upon a dry, smooth and
plain horizontal surface.
2.
Plug in to the electric mains with the same volt-
age as indicated on the nut maker case. The
red indicator (4) will light on. Please, wait for
5-8 minutes. Once the appliance is ready for
use, this indicator goes out.
1.
Always unplug and let your appliance cool
down before cleaning.
2.
Wipe the nut maker case
Do not use the appliance until it dries out com-
pletely. Do not use abrasive materials, alcohol,
gasoline, etc., to clean the appliance.
3.
Wipe the non-stick panels
wet cloth or sponge. Do not clean panels with
6
(5) with margarine
(1) with wet cloth.
(5) with soft, slightly

Advertisement

Table of Contents
loading

Table of Contents