Installing The Remote Control Devices - TOHATSU MFS 9.8A3 Owner's Manual

2. Installing the remote control devices

It is recommended that you consult
w i t h y o u r a u t h o r i z e d d e a l e r f o r
installation and adjustment of the
remote control device.
Installation of the Remote Control
Cables (Box side) :
Follow the instruction manual
provided with the remote control.
Installation of the Remote Control
on your boat :
Follow the instruction manual
provided with the remote control.
Installation of the Remote Control
Cable (engine side) and the Cord
Assembly (Wiring Harness) :
Fitting of connecting parts to
cables
Screw the tip of the remote control
cable into the cable joint up to
approx. 10 mm (0.39 inch), then lock
them with a lock nut. Apply grease to
the hole of the cable joint.
Lock nut
Remoto control cable
Cable joint
Approx. 10mm
(0.39 inch)
Fitting of Remote Control Cable to
Engine.
Note
Put the control lever in the Neutral
position and the Free Accel lever in
the fully closed position.
Shift Cable Throttle Cable
�������
!
Be careful not to loop remote control
cables to diameter of 406 mm (16
inches) or less.
Note
Confirm the engine shifts correctly
when the shift lever is placed in
Forward and Reverse position. also
confirm the throttle valve is closed
at idle, in Neutral, Forward, and
Reverse. Confirm the throttle valve
is fully open when in Forward at the
wide open position.
17
INSTALLATION
Cable Harness
1
2
3
4
5
6
7
8
9
10
11
12
13