Table of Contents
Advertisement
S
S
UPER
ERVER 8026B-6RF/8026B-TRF User's Manual
Unpacking
When unpacking the system, make sure the person handling it is static protected.
Figure 6-1. Front and Rear Chassis Views
Power Supplies (2)
USB Ports
COM1 Port
6-2
Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the Control Panel PCB (printed circuit
board). Make sure the red wire plugs into pin 1 on both JF1 and JP4. Pull all ex-
cess cabling out of the airfl ow path. The LEDs inform you of system status. See
Chapter 3 for details on the LEDs and the control panel buttons. Details on JF1
can be found in Chapter 5.
USB Ports, COM Port
Slim Floppy Drive (optional)
Dedicated LAN Port
VGA Port
Ethernet Ports
6-2
DVD Drive (optional)
SAS/SATA Drives (6)
UID Button
7 Low-Profi le PCI Slots
Control Panel
Advertisement
Table of Contents
