Control Panel; System Fans - Supero SUPERSERVER 6026TT-BTF User Manual

S S
UPER ERVER 6026TT-BT(R)F/BIBX(R)F/BIBQ(R)F User's Manual
Node B Control Panel
Node A Control Panel
Dedicated IPMI LAN Port
PCI-Express x16 Slot
LAN Ports
USB Ports COM Port VGA Port
*The Infi niBand ports are included on the 6026TT-BIBX(R)F and 6026TT-BIBQ(R)F only.
**Redundant power is included on the 6026TT-BTRF/BIBXRF/BIBQRF models only.
6-2

Control Panel

Each control panel on the front of the chassis must be connected to the JF1 con-
nector on its associated serverboard to provide you with system control buttons
and status indicators.
These wires have been bundled together in a ribbon cable to simplify the connection.
Connect the cable from JF1 on the serverboard to the control panel PCB (printed
circuit board). Make sure the red wire plugs into pin 1 on both connectors. Pull all
excess cabling out of the airfl ow path. The LEDs inform you of system status for
the serverboard it is connected to. See Chapter 3 for details on the LEDs and the
control panel buttons. Details on JF1 can be found in Chapter 5.
6-3

System Fans

The system has four hot-swappable 8-cm PWM fans to provide the cooling for all
four nodes. The fans connect directly to the backplane but receive their power from
the serverboard they are connected to logically. Fan speed may be controlled by a
setting in BIOS (see Chapter 7).
Figure 6-1. Chassis Front View
SATA Drives
Figure 6-2. Chassis Rear View
Dedicated IPMI LAN Port
Power Supply**
Infi niBand Port* USB Ports COM Port VGA Port Infi niBand Port*
6-2
Node D Control Panel
Node C Control Panel
LAN Ports PCI-Express x16 Slot