Installing A Cpu Heatsink - Supero SUPERSERVER 6026TT-BTF User Manual

Installing a CPU Heatsink

1. Remove power from the system
and unplug the AC power cord
from the power supply.
2. Do not apply any thermal grease
to the heatsink or the CPU die;
the required amount has already
been applied.
3. Place the heatsink on top of the
CPU so that the four mounting
holes are aligned with those on
the (preinstalled) heatsink reten-
tion mechanism.
4. Screw in two diagonal screws (i.e.
the #1 and the #2 screws) until
just snug. Do not fully tighten the
screws or you may damage the
CPU.)
5. Add the two remaining screws
then fi nish the installation by fully
tightening all four screws.
Note: see Chapter 6 for details on installing the air shroud.
Chapter 5: Advanced Serverboard Setup
Screw #1
Screw #1
Install Screw #1
5-5
Screw #2
Screw #2