Removing And Carrying The Outboard Motor; Removing The Outboard Motor; Carrying The Outboard Motor - TOHATSU MD 30B2 Owner's Manual

58

REMOVING AND CARRYING THE OUTBOARD MOTOR

1. Removing the outboard motor

Stop the engine.
1 Disconnect the fuel connector, the
remote control cables, the battery
cords, bracket fixing bolts and
2
nuts etc.
Remove the outboard motor from
the hull and completely drain the
3
water from the gear case.
!
4
Do not carry the outboard motor
immediately after stopping engine
5
when they are so hot that they burn
hands if touched.
6
7
8
9
10
11
12
13
14
�������

2. Carrying the outboard motor

Be sure to keep the engine vertical
whenever you carry the outboard motor.
�������
!
Close air vent screw of fuel tank and
fuel cock before carrying or storing
outboard motor and fuel tank, or fuel
may leak, potentially catching fire.
EFTO, EPTO type
When carrying or putting the engine
up for storage, make sure the side
with the electric motor of the Power
Trim and Tilt is down otherwise air will
enter the pump system for the Power
Trim and Tilt operation.
EFO type
Lay the engine with the shift lever up.