TOHATSU MD 30B2 Owner's Manual page 40

40
ENGINE OPERATION
Install a lock in the stop switch.
1
2
3
4
Stop switch
5
Hook
6
Feed fuel to the carburetor by
squeezing the primer bulb until it
7
is firm.
Engine side
8
9
10
11
Forced fuel feeding
W h e n t h e e n g i n e i s n e w, s t o p s
12
because of emptying fuel tank or
have been left without operation for
a long time, or just after the engine is
13
overhauled, be sure to execute the
following operation for feeding
14
Lock
Stop switch
Lock
Emergency stop line
Fuel tank side
the engine with fuel forcedly before
starting the engine.
a. Repeat to squeeze the primer bulb
until it becomes firm.
b . S e t t h e m a i n s w i t c h t o " O N "
position and hold it turned on for
3 seconds. − To actuate the FFP
(Fuel Feed Pump).
c. Tur n off the main switch and
again squeeze the primer bulb
repeatedly until it becomes firm.
d. Repeat the above steps b and c
until the primer bulb remains as it
is firm.
Forced engine oil feeding
When the engine is new or have been
left without operation for a long time,
or just after the engine is overhauled,
be sure to execute the following
operation for forcedly feeding the
engine oil to the oil line before starting
the engine.
30 40, 50 type
a. Disconnect the link rod by turning
the rod snap interlocking with the
oil pump as shown in the figure.
b. Make sure that the oil pump control
lever is set at open side position.
c. Idle the engine for more than 30
minutes.
d. Reset the link rod to the advancer
arm.