TOHATSU MD 30B2 Owner's Manual page 38

Outboard motor
Hide thumbs Also See for MD 30B2:
Table of Contents

Advertisement

38
PRE-OPERATING PREPARATIONS
Battery voltage too low
If the battery voltage drops to 10 V or
lower, the warning lamp flashes.
1
And also if the voltage is too high, all
of the three warning lamps flash.
If the battery is defective or the
2
battery cable is poorly connected, the
warning lamp flashes and the engine
speed is automatically slowed down
3
to 2,800 to 3,200 rpm. If the defect is
serious, the engine will stop.
4
5
6
7
8
Remedy:
Check the battery cable connection.
9
If there is a poor connection,
reconnect it tightly.
Charge the battery.
10
Replace the battery with a new
one.
11
12
13
14
Battery warning lamp
Engine trouble
In case of an engine trouble, all the
three warning lamps flashes at the
same time.
Note
This warning system has three kind
indications with cause of engine
trouble as below.
The warning lamp flash
The engine speed control 2,800
~3,200 rpm and the warning lamp
flash
The engine speed control 700~900
rpm and the warning lamp flash.
Remedy:
Consult your dealer about the trouble,
because the engine needs inspection
and repair service by an authorized
serviceman in this case.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Md 115b2Md90c2Md 115a2Md 75c2

Table of Contents