TOHATSU MD 30B2 Owner's Manual page 72

72
INSPECTION AND MAINTENANCE
!
You may be injured due to high engine
temperatures if you fill engine oil just
1
after stopping. Changing engine oil
should be done after the engine has
been cooled.
2
!
3
Do not overfill engine oil, or engine
oil could leak and/or engine could be
damaged. If engine oil level is over
4
upper limit marks of oil gauge, drain
oil to level lower than upper limit.
Be sure that outboard motor is in
5
upright and level position when
checking or changing oil.
Stop engine immediately if low oil
pressure warning lamp is lit or oil
6
leak is found, or engine could be
severely damaged. Consult dealer.
7
Notes
8
If any amount of water is found in
engine oil, making it milky white,
consult dealer.
If engine oil is contaminated with
9
fuel, emitting strong fuel smell,
consult dealer.
10
11
12
13
14
�������
�������
Checking and Refilling Oil in the
Power Trim & Tilt.
Check the oil level of the reservoir
tank as shown on the right while
the tank is kept in a ver tical
position. Tilt the engine up to
check the oil level in the tank.
Remove the oil cap by turning
counter-clockwise, then check if
the oil level reaches the bottom
line of the plug hole.
Oil cap
Oil cap
Oil level
30 40 50 115
�������
!
Be sure that outboard motor is
secured to transom or service
stand, or accidental drop or fall of
outboard motor could lead to severe
personal injury.
Be sure to lock outboard motor if
it is tilted up, or accidental fall of
outboard motor could lead to severe
personal injury.
Do not go under outboard motor
tilted up and locked, or accidental
fall of outboard motor could lead to
severe personal injury.
Oil
level