TOHATSU MD 30B2 Owner's Manual page 24

24
INSTALLATION
Adjust the cable joint (shift side) so
that the hole meets with the shift
arm pin, and lock the cable joint
1 with the nut, and insert the shift
arm pin and then secure with a
washer and R-shaped pin. Also,
2
adjust the cable joint (throttle
side) so that the hole meets with
the advancer arm pin, and lock
3
the cable joint with the nut, and
insert the advancer arm pin and
then secure with a washer and
4
R-shaped pin.
Rod snap
5
Link rod
6
7
8
R shaped pin
9
10
11
12
13
14
Cable Joint
Throttle
Cable
Nut
Bolt
Screw
Bracket
Connecting the Remote Control Cable
to the engine [115]
Turn the three hook levers fastening
the bottom cowl and then remove
the top cowl.
Remove the hose clamp fastening
the cord grommet.
Remove the bolts fastening the
cord clamp and then remove the
cord clamp and the cord grommet.
Hose clamp
Hole for
cord ass'y B
Hole for remote
Hole for meter
control cable of
cord ass'y
Shift side
Bolt
Cord clamp
Cord grommet
Detach the throttle and shift cable
Joints by removing the R-shaped
pins.
Hook lever
Hole for
trim sender
extension cord
Hole for remote
control cable of
throttle side
Hole for fuel hose
Hose clamp