Removing And Carrying The Outboard Motor; Removing The Outboard Motor; Carrying The Outboard Motor - TOHATSU MFS 4D Owner's Manual

REMOVING AND CARRYING THE OUTBOARD MOTOR

ENOM00070-K
1. Removing the outboard
motor
ENOW00064-1
CAUTION
Engine may be hot immediately after opera-
tion and could cause burns if came in con-
tact. Allow engine to cool down before
attempting to carry the outboard.
1
1. Cooling water check port
1. Stop the engine.
2. Close air vent screw of fuel tank and
fuel cock.
3. Disconnect the fuel connector, the
remote control cables and the bat-
tery cables from the outboard motor.
4. Remove the outboard motor from
boat and completely drain the water
from the gear case in a vertical posi-
tion.
ENOM00071-A

2. Carrying the outboard motor

ENOW00933-0
Be sure to disconnect fuel connector except
when operating engine.
ENOF00437-2
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00065-1A
Close air vent screw of fuel tank and fuel
cock before carrying or storing outboard
motor and fuel tank, or fuel may leak, poten-
tially catching fire.
ENOW00066-1
Do not give a shock to an outboard motor
during transportation.
Do not carry or store outboard motor in
any of positions described below.
Otherwise, engine's exterior may be dam-
age d or wa ter may en ter th e cylinder
through the exhaust port and cause engine
problems.
ENOF01505-1
WARNING
WARNING
CAUTION
45
8