TOHATSU MD 30B2 Owner's Manual page 26

26
INSTALLATION
Install the hose clamp to the cord
grommet.
Install the cord clamp.
1
Bolt
2
Cord clamp
3
4
5
Adjust the cable joint (shift side) so
6
that the hole meets with the shift
arm pin, and lock the cable joint
with the nut, and insert the shift
7
arm pin and then secure with a
washer and R-shaped pin. Also,
adjust the cable joint (throttle
8
side) so that the hole meets with
the advancer arm pin, and lock
9
the cable joint with the nut, and
insert the advancer arm pin and
then secure with a washer and
10
R-shaped pin.
Throttle cable joint
11
12
13
Shift arm
14
Hose clamp
R-shaped pin
Washer
Shift cable joint
Connecting Cords and cable
Connect cable harness B and
meter lead wire to cable harness A.
Cable
Hamess A
Connect the trim sender and the
extension cable trim sensor.
Bottom cowl
Extension cable
trim sender
�������
!
Do not disconnect the electric couplers
while the engine is running, as this will
damage the C.D. unit and could result
in a serious electric shock.
Cable
Hamess B
Meter lead wire
Trim sender cable