BLEEDING THE HYDRAULIC BRAKE SYSTEM/
ADJUSTING THE SHIFT PEDAL
g. Loosen the bleed screw.
NOTE:
_
Loosening the bleed screw will release the
pressure and cause the brake lever to contact
the throttle grip or the brake pedal to fully
extend.
h. Tighten the bleed screw, and then release
i. Repeat steps (e) to (h) until all of the air
j. Tighten the bleed screw to the specified
k. Fill the brake fluid reservoir to the proper
_
After bleeding the hydraulic brake system,
check the brake operation.
L
ADJUSTING THE SHIFT PEDAL
1. Check:
3 - 41
the brake lever or brake pedal.
bubbles have disappeared from the brake
fluid in the plastic hose.
torque.
Bleed screw
14 Nm (1.4 m · kg, 10 ft · lb)
level with the recommended brake fluid.
Refer to "CHECKING THE BRAKE FLUID
LEVEL".
WARNING
LLL
L LLL
L
L LLL
L
L LLL
• shift pedal position
(distance a from the top of the rider foot-
rest to the top of the shift pedal)
Out of specification → Adjust.
Shift pedal position
(from the top of the rider footrest
to the top of the shift pedal)
15.0 mm (0.59 in)
CHK
ADJ
L
L LLL
L
L LLL
L
LLL